Sprinkler suction operation

(1) The sprinkler should be as close as possible to the operating point and parked.

(2) Open the side door of the pallet box, take out the water suction hose, and swing it backwards without bending.

(3). Pump the suction hose into the water as deep as possible to ensure that the pipe end is always below 300mm from the liquid surface during the operation.

(4). Push the handle of the four-way valve to be perpendicular to the ground.

(5). Put the transmission into neutral, then start the engine, disengage the clutch, pull the power take-off switch backward, and then the power will be taken off by the gear, and the pump will start to run.

(6) The operator can pass the observation mirror on the upper part of the rear head. When the liquid level reaches the middle of the observation mirror, the driver should be notified, and the colleague should quickly pull the water suction hose away from the water surface or close the four-way valve.

(7) After putting away the hose, put it back in the pallet box and close the side door.

(8) Drive the sprinkler away from the pumping site.